One size does not fit all. Did you know that One Size fits all Spring Heel Straps may cause excessive coil expansion when used on a larger boot? This excessive coil expansion can facilitate line entanglement in between the expanded coils!

OMS^® Spring heel straps come in sizes S, M, L, and XL to insure proper fit and help eliminate excessive coil expansion and entanglements! The springs expand and contract to automatically adjust and compensate for expansion and compression of the divers dry suit boot. The 4.5” Achilles rubber pad provides unprecedented comfort in the heel area and aids in donning and doffing of the fin.

The FS series is designed to fit OMS^® Slipstream^® and most fins with a standard "Wire" point of attachment.

TEIL #     Description

FS-1-S       Small Heel Strap for F-Stream
FS-1-M      Medium Heel Strap for F-Stream
FS-1-L       Large Heel Strap for F-Stream
FS-1-XL    X-Large Heel Strap for F-Stream

A fin so revolutionary that the U.S. Navy cut their swim time by 1 minute on a 500 Meter Swim ! This proven fin design is manufactured from a lightweight, neutrally buoyant Monoprene resin that results in better trim positioning with maximum thrust on the down kick and minimal resistance on the up kick

The FT series is designed to fit OMS^® Thrust^® and most fins with a plastic buckle and standard “Nail head attachment” point.

TEIL #     Description

FT-1-S       Small Heel Strap for F-Thrust
FT-1-M       Medium Heel Strap for F-Thrust
FT-1-L        Large Heel Strap for F-Thrust
FT-1-XL     X-Large Heel Strap for F-Thrust

The Thrust™ fin is specifically engineered to fit dry suit boots and for 2008 has been re-engineered with a new distortion resistant Monoprene blade with higher durometer for significantly increased propulsion.

Die OMS ^® Thrust ™ Flossen wurden speziell für das komfortable Passen über Ihre Trockentauchstiefel entworfen. In den 1,5 Jahren am Markt haben wir beispielhafte Berichte über Folgendes erhalten: Bequeme Passform und die Verminderung von schmerzhaften Fuß.- und Beinkrämpfen (verursacht vom unpassenden Schnitt der Fußöffnungen bei Flossen des Mitbewerbes), erhöhter Schub durch gute Passform zwischen der Fußöffnung und dem Trockentauchstiefel und dem hydrodynamischen Design des Flossenblatts.

Thermisch stabiles Monoprene wird zur Vermeidung der Verformung der Flossenblättern wie aus dem "Heißen Auto" und für einen verbesserten Rückschlag verwendet.